Skip to main content
November 13, 2018 ...

News

  • Hope you enjoy the new look of the forum.

Topic: 101 hero is calibrated but having problems (Read 1069 times) previous topic - next topic

  • Leoleo
  • [*]
101 hero is calibrated but having problems
As seen in pics below screws are all the way in and I did paper test all should be good but I'm having this problem second pic is from first print when I calibrated it's doing the infill at the wrong spot why is that? And on first pic after a couple of test print it's behaving like its not calibrated I eye checked it and therers not drag and screws are all the way in and I don't want to screw in more because I'm afraid of breaking it this is my first printer   also I'm using simplify3d

  • BobC
  • [*][*]
Re: 101 hero is calibrated but having problems
Reply #1
Your base is installed upside-down!  The smooth side goes up.