just to verify, you did unzip the file to get the 101hero file only on the SD card? next step would be to try to put pressure on top of the sd card slot to make sure its making a good connection.
Download and use the "Back Home" file from - http://www.101hero.com/downloadif done correctly, this will home the hotend, just to make sure it is working.. After that try the motor test, same download page. Work your way down that list, where does it stop?
AND/ORPlug in a USB cable to the 101Hero controller, connect the other end of the cable to your computer.The 101hero site has links to drivers if required - http://www.101hero.com/download bottom of pageInstall Ponterface, set the COM port the the port # of the 101Hero, set baud rate to 15200, Connect.On the left-hand pane it You should see status messages that should help figure out what is going on.
Connecting...echo:SD card okecho:enqueing "M23 101hero"echo:enqueing "M24"Printer is now online.open failed, File: 101hero
I got the same result until I added the 'ini' file to the SD card.
Quote from: thetraindispatcher on 07 Apr, 2017, 22:50:19 PMI got the same result until I added the 'ini' file to the SD card.I'm not sure what that is or where I would find it. Where did you get the 'ini' file?
Page created in 0.130 seconds with 17 queries.