Skip to main content
April 24, 2018
Hope you enjoy the new look of the forum.
Topic: CURA 2.5
(Read 1268 times)
05 Jun, 2017, 10:38:49 AM
I have downloaded the latest version of CURA for Mac : 2.5.0
Hero 101 seems to have a native support. No configuration needed anylonger.
Did anyone try it ?
: 05 Jun, 2017, 10:49:22 AM by scscjcnc
Re: CURA 2.5
07 Jun, 2017, 02:26:22 AM
I tried the Win10 version of 2.6.0-beta. I really like all the extra controls that are exposed (especially acceleration: my printer was shakin' and quakin').
But I hate that it doesn't work with Pronterface. I can still run Pronterface separately, but the integration is sorely missed.
The prints I did were noticeably better, but also took 2x longer to print (lots more head motion to make things nicer). Not a good match for a terribly slow 101Hero, where even a tiny print can take an hour.
So I went back to 15.04.6.
Re: CURA 2.5
08 Jun, 2017, 01:05:47 AM
I'd love to give it a go but my new install of Linux mint doesn't want to play nice with the app image from the Ultimake site.
I might try a repo install later on though. Sound like it might be worth a try
: 08 Jun, 2017, 01:11:36 AM by Admin
powered by ElkArte 1.0.10
SimplePortal 2.4 © 2008-2014
Page created in 0.119 seconds with 19 queries.