Skip to main content
February 20, 2018 ...
OpenID

News

  • Hope you enjoy the new look of the forum.

Topic: simplicity3d settings (Read 596 times) previous topic - next topic

simplicity3d settings

Good afternoon, does anyone know how to configure the printer in simplicity3d?
Thank you

  • Admin
  • [*][*][*][*][*]
  • Administrator
Re: simplicity3d settings
Reply #1
I believe Angus from Makers muse is going to post his factory settings at some point. The website for simplify3d also says that it compatible with the 101Hero so you should be able to pick it out from the drop down menu

Re: simplicity3d settings
Reply #2
Ok, thank you!!!

Re: simplicity3d settings
Reply #3
The website for simplify3d also says that it compatible with the 101Hero so you should be able to pick it out from the drop down menu

Where do you get that from? I can't pick out 101Hero from the list of known machines.

  • Admin
  • [*][*][*][*][*]
  • Administrator
Re: simplicity3d settings
Reply #4
There is a compatability checker on their website. When I typed in 101hero it came up.

https://www.simplify3d.com/software/check-compatibility/

  • Ken_A
  • [*][*]
Re: simplicity3d settings
Reply #5
came up for me too.. I downloaded the program, and it wasn't there. I chose other and put settings in, then did a load fff profile. I used one of the 101hero models renamed to 101hero.gcode, and that imported just fine.... Now when I ty to print from a cura file or the simplify3d file, the print head wanders around all the axis.

  • Ken_A
  • [*][*]
Re: simplicity3d settings
Reply #6
I got it to work if you want to try my firmware settings

  • Ken_A
  • [*][*]
Re: simplicity3d settings
Reply #7
And I've been tweeking. this file has a better raft applied.  much easier to remove.

  • Admin
  • [*][*][*][*][*]
  • Administrator
Re: simplicity3d settings
Reply #8
Angus on makers muse has posted his simplify3d settings on this video. 

https://youtu.be/UKdnONOKskQ

  • Bucky208
  • [*][*]
Re: simplicity3d settings
Reply #9
If anyone is still looking for the S3D profile, i uploaded a FFF file in the Facebook 101 hero group (files section).
It has the exact settings as the 101land models. (They are made with S3D)

  • Bucky208
  • [*][*]
Re: simplicity3d settings
Reply #10
Uploaded it to the cloud: https://mdgcloud.be/s/3Mdn6oWVeThgrHx