i am curious about something. if you have a multi meter. i have circled the resistor in green in the picture. it should be labeled 472 and measure around 4.7k oms. i suspect you have a higher resistance across that resistor, either due to defect in the resistor, or the wrong one got into the pick and place machine in the factory. if its possible can you take a look at it, and test it?
swed: i am just following traces and reading documentation i am finding online. still tracing more circuits to see if i can find your issue, it might end up being that the controller chip is just stupid and needs replaced.yaowenc: the MINTEMP is slightly different, a higher resistance is being found, have you checked the resistance across the thermistor? it should be round about 100k ohm at room temp give or take. also, you might need to check that everything is plugged in fully just to be on the safe side.
Page created in 0.128 seconds with 19 queries.