Skip to main content
February 20, 2018 ...
OpenID

News

  • Hope you enjoy the new look of the forum.

Topic: upscaling 101hero (Read 528 times) previous topic - next topic

  • bjacob
  • [*]
upscaling 101hero
Over the past few days, I've been trying to figure out how to upscale the 101hero, but the 101hero's board wont let me go beyond 100mm on the z-axis. Has anyone been able to work around that?
  • Last Edit: 11 Jun, 2017, 21:35:53 PM by bjacob

  • Admin
  • [*][*][*][*][*]
  • Administrator
Re: upscaling 101hero
Reply #1
The firmware appears to be locked down on the 101hero.  There has been some discussion about using different boards but that was in relation to upgrading the printer as a whole