Skip to main content
September 20, 2018 ...

News

  • Hope you enjoy the new look of the forum.

Topic: Stand Module Order (Read 356 times) previous topic - next topic

  • 3DVol
  • [*][*]
Stand Module Order
I am new to this type of printer.  Does the order of the Stand Module matter?  The stepper motors are labeled A, B and C.  Does it matter if they are arranged in order clockwise or counterclockwise?

  • rcojoe
  • [*][*]
Re: Stand Module Order
Reply #1
If you have two swapped, then it will print mirrored, which I didn't know was going on till i tried to print letters.  To fix,  just swap two of the servo plugs and stop switch plugs around.  It doesn't matter which two.

Joe

  • 3DVol
  • [*][*]
Re: Stand Module Order
Reply #2
Thanks.  I had a similar problem on my 3 axes printer.

  • 3DVol
  • [*][*]
Re: Stand Module Order
Reply #3
I just saw a video that shows that the pylons should be arranged in a counterclockwise order, A, B, C, when looking down on the machine.  Clockwise when looking at the bottom.  Waiting on a replacement motor to be able to test it out.